MH-60335201家电稳定性试验台| IEC60335电器稳定性测试台/|GB4706倾斜试验平台

MH-60335201家电稳定性试验台| IEC60335电器稳定性测试台/|GB4706倾斜试验平台

产品概述：

家电稳定性试验台符合GB4706-1/IEC60335-1等标准第20.1节稳定性和机械危险要求，用于验证家用和类似用途电器在一定的倾斜角度下（角度0～30°）转动的稳定性试验，也可订制符合UL标准的0~42°稳定性试验台。

技术参数：

GB4706-1标准要求：

20.1 除固定式器具和手持式器具以外，打算在一个表面，例如地面或桌面上使用的器具，应有足够的稳定性。

通过下述试验检查其合格性，带有器具输入插口的器具，要装上一个适合的连接器和柔性软线。

器具以使用中的任一正常放置状态放在一个与水平面成 10°角的倾斜平面上。电源软线以最不利的方位摆放在

倾斜平面上。但是，如果器具放在一个水平面上并被以 10°角倾斜后，其通常不与支撑平面接触的部分与此平面

接触，则把器具该放在一个水平支承上，并以最不利的方向将其倾斜 10°角。

注： 

1、器具不与电源连接。

2、对装有滚轮、自位脚轮或支脚的器具，可能需要在水平面上进行该试验。

带有门的器具，以门打开或关闭的状态进行该试验，二者取最不利的情况。

打算在正常使用中由用户充灌液体的器具，要在空的状态，或充灌最不利的水量，直到制造厂标出的容量的状

态，进行试验。

器具不应翻倒。

带电热元件的器具，要在倾斜角增大到 15°的状态下，重复该试验.如果器具在一个或多个方位上翻倒，则它

要在每一个翻倒的状态下经受 11 章的试验。

在该试验期间，温升不应超过表 7中所示的值。

注： 

3、将自位脚轮或滚轮挡住，以防止其滚动。

IEC60335-1

20 Stability and mechanical hazards 

20.1 Appliances, other than  fixed appliances and  hand-held appliances, intended to be used on a surface such as the floor or a table, shall have adequate stability. 

Compliance is checked by the following test, appliances incorporating an appliance inlet being fitted with an appropriate connector and flexible cord. 

The appliance, not connected to the supply mains, is placed in any normal position of use on a plane inclined at an angle of 10° to the horizontal, the supply cord resting on the inclined plane in the most unfavourable position. However, if part of an appliance comes into contact with the horizontal supporting surface when the appliance is tilted through an angle of 10°, the

appliance is placed on a horizontal support and tilted in the most unfavourable direction through an angle of 10°.

NOTE

The test on the horizontal support may be necessary for appliances provided with rollers, castors or feet. In this case, castors or wheels may be blocked to prevent the appliance from rolling.

Appliances provided with doors are tested with the doors open or closed, whichever is the more unfavourable. 

Appliances intended to be filled with liquid by the user in normal use are tested empty or filled with the most unfavourable quantity of water up to the capacity indicated in the instructions.

The appliance shall not overturn. 

The test is repeated on appliances with heating elements with the angle of inclination increased to 15°. If the appliance overturns in one or more positions, it is subjected to the tests of Clause 11 in each of these overturned positions. 

During this test, temperature rises shall not exceed the values shown in Table 9.