深圳市美华安规仪器有限公司
地址: A. 深圳光明新区光明
圳美311号/518107
B. 东莞大岭山镇渭
溪路/523829
热线: 155-0203-6348;
136-1283-4185
电话: 0755-3288-5887
传真: 0755-3288-5887
Q Q: 1-4848-7-5858;
4-9327-8805
邮箱: sm#ag17.wang
okgang#163.com
(#请改@)
官网: www.ag17.wang
论坛: bbs.ag17.wang
澳洲AS/NZS 3112 图B1两插扁平插脚量规|125V两平行扁平插销插头量规|FIGURE B1-GAUGE FOR TWO-PIN FLAT-PIN 125 V MAX. PLUGS|Figure B1-Gauge
澳洲AS/NZS 3112插头插座量规汇总清单方便查询各量规: http://www.ag17.wang/product/AS_NZS3112_Gauge.html
标准:符合AS/NZS 3112-2012(或最新版)要求;
使用要求:
低压扁平插片插头和具有一个圆形接地片及二个扁平带电插片或二个圆形带电片及一个扁平接地片的低压插头应符合图 2.1所示的呎寸. 任何插头的带电片与插头注塑边缘之间的距离应不小于9mm.当怀疑符合此要求时, 将附录A的图A1或附录B的图B1或附录F的图F1(a), F1(b)的适当治具置于插片上以接触插头面的最高点.使用宽度大于 3mm的 1.5mm厚薄规插入插头和插头治具之间(不用力),在 9mm 之内应不可接触到带电插片.
Low voltage flat-pin plugs and low voltage plugs having one round earth pin and two flat live pins or two round live pins and one flat earth pin, with ratings up to and including 20 A, shall conform to the appropriate dimensions shown in Figure 2.1.
In addition to the dimensions of Figure 2.1, the distance between a live pin of any plug and the edge of the moulding of the plug shall be not less than 9 mm. Where doubt exists regarding compliance with this requirement, the gauge of Figure A1 in Appendix A or Figure B1 in Appendix B, or Figure F1(a) or F1(b) in Appendix F, as appropriate, shall be placed over the pins to ensure contact with the highest points associated with the plug face.
Using a 1.5 mm feeler gauge of greater than 3 mm width and applied without undue force between the plug and the plug gauge, penetration to within 9 mm of the live pin shall not be possible.
数量:1个。
安规仪器网/美华安规仪器---追崇原创、重视知识产权和尊重劳动成果,也是行业发展主旨,禁止盗链、采集、复制及转载等非法行为,一经发现保留追责权力。