澳洲AS/NZS 3112 图D1非正常插入的三扁平插销测试插头|试验插头| FIGURE D1-THREE-PIN TEST PLUG FOR CHECKING THREE-PIN FLAT PIN 250 V MAX. SOCKET-OUTLETS AGAINST INCORRECT INSERTION OF PLUGS, IN ACCORDANCE WITH CLAUSE 3.8.2

澳洲AS/NZS 3112 图D1非正常插入的三扁平插销测试插头|试验插头| FIGURE D1-THREE-PIN TEST PLUG FOR CHECKING THREE-PIN FLAT PIN 250 V MAX. SOCKET-OUTLETS AGAINST INCORRECT INSERTION OF PLUGS, IN ACCORDANCE WITH CLAUSE 3.8.2|Figure D1-Test plug
标准：符合AS/NZS 3112-2012（或最新版）要求；

规格：10A、15A和20A各1个；

数量：依采购；

澳洲AS/NZS 3112插头插座量规汇总清单方便查询各量规： http://www.ag17.wang/product/AS_NZS3112_Gauge.html
使用要求：
插座的设计和结构应为除在正常插入时,插头的任何插片不能接触带电弹夹. 对于插座(用于如图2.1(f)和图2.1(g)所示的3PIN插头) 应使用如附录D的图D1所示呎寸的适当测试插头进行检查. 注释: 该条款用于防止插头的一个插片插入而其它插片在插座之外,以及防止接地插片插入带电弹夹. 对于具有可除去的面板的插座,应带面板和不带面板进行测试.
The design and construction of a socket-outlet shall be such that it is not possible for any pin of a plug with which the socket-outlet may appropriately be used to touch a live contact except during normal insertion, i.e. with each pin entering or adjacent to the aperture for the appropriate contact.
Socket-outlets for use with three-pin flat pin plugs of the type shown in Figure 2.1(a) and Figure 2.1(d), and two-pin flat pin plugs of the type shown in Figure 2.1(c) and Figure 2.1(d), shall be checked for compliance with this requirement by means of an appropriate test plug having the dimensions shown in Appendix D, Figure D1.
NOTE: This provision is intended to prevent the insertion of one pin of a plug while the other pin or pins are overhanging the socket-outlet, and to prevent the insertion of an earthing pin in a live contact.
For socket-outlets with faceplates that are intended to be removed for interchangeability, this test shall be conducted with and without the faceplate in position.